Fluke 80i-110s AC/DC current clamp
The 80i-110s is a current probe that clamps around a conductor and converts the current into a signal that can be read on a measuring instrument with a BNC input. It is used when you want to measure current without breaking the circuit, and it can therefore be practical for troubleshooting and measuring on installations, electronics, and motor controls.
It measures both AC and DC, so it can be used for both alternating current and direct current. There are two measurement ranges, and the output switches between 100 mV/A and 10 mV/A depending on the range. This makes it easy to connect to a ScopeMeter, an oscilloscope or other equipment that can read a voltage signal from the probe.
What makes it relevant in practice is especially the combination of current measurement without interruption, the isolated BNC connection, and the wide frequency range up to 100 kHz. It can therefore be used when looking at both current level and the current's waveform over time. At the same time, it is built for conductors with a diameter up to 11.8 mm, so it fits many common measuring points.
For a multimeter, it can also be used with a BNC-to-banana adapter. This makes it more flexible if the current needs to be read on different measuring equipment.
You can read more here:
See datasheet from the manufacturer
Specifications
- AC/DC current probe with clamp measurement
- Output via isolated BNC connection
- Measurement ranges: 0.1 A to 10 A and 1 A to 100 A
- Output signals: 100 mV/A and 10 mV/A
- Usable frequency range: DC to 100 kHz
- Maximum conductor diameter: 11.8 mm
- Safety category: CAT II 600 V and CAT III 300 V
- 1.6 m output cable
- Compatible with Fluke ScopeMeter test tools and oscilloscopes
- BNC-to-banana adapter can be used for multimeter
- Article number: 114519
The content has been generated using AI - we reserve the right to make errors.
Contact HIN for further information about the product.